Re: Twin co-ax outlets

["Paul Miller" <pmiller@xxxxxxx>]

Phil,

I have three cable decoders in my house two in bedrooms and one in the
living room, I just asked Nynex (twas them at the time) to change the
output
frequencies of the set top box to different frequencies as they are all
connected, and lo and behold they did (remotely).

I hope it helps


Paul

-----Original Message-----
From:	phil.hooker@xxxxxxx [mailto:phil.hooker@xxxxxxx]
Sent:	17 February 1999 15:04
To:	ukha_d@xxxxxxx
Subject:	[ukha_d] Re: Twin co-ax outlets

Thanks for using NetForward!
http://www.netforward.com
v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v^v

The socket I was using is a twin outlet from Maplins. If I just connect one
of my cables it works fine. If I bring the other cable near to the
connecting block the interference starts, even though it is not touching.
It
seems to be the cable ends being near each other that causes the problem. I
went into B+Q to see what outlets they had and noticed in small print on
the
back of the box that they were unsuitable for seperate sources! Well what
is
the point of a twin outlet that must have the same source!


> >I have two cables running from two different cable TV decoders.
They both
> output the cable
> >channel on the same frequency. I want to plug different devices
into them
> (TV in one and video
> >in the other) so I can watch one cable channel and record a
different
one.
>
> >What I get on the screen is BOTH cable channels at the same time
in my
> technical terms that
>
> That _doesn't_ sound right.  If anything, with a _very_ poorly made
> connection, you might get a _tiny_ hint of what is on the other
channel at
> the same time, but even that should be unlikely.
>
> What sort of outlet is it?  Where did you get it, what is the order
code
> etc?  If it is 2 separate sockets on a plate, there should be no
problem-
> if it is 2 sockets with common grounds on a metal plate, I could see
that
> there _might_ be a problem, but unlikely (ie only if you had managed
to
> swap signal and screen connections at some point in the cable.  I
suspect
> from your problem that they are interconnected in some way, but
without
> knowing the specific make and model, it's hard to tell.
>
> A well made connection should be no worse than running 2 co-ax cables
> alongside each other, in this sort of application.
>
> Nigel
>

------------------------------------------------------------------------
Track your stocks and funds in a StockMaster portfolio.  With easy
setup, you get quotes, charts, and news for them all on just one page.
No limits, fast loading, and FREE!   http://www.stockmaster.com/?a=f8

eGroup home: http://www.eGroups.com/list/ukha_d
Free Web-based e-mail groups by eGroups.com




------------------------------------------------------------------------
Tired of waiting for your stock quotes and charts to load?
StockMaster is super-fast for quotes, charts, news, and portfolios.
Markets don't wait, why should you?  http://www.stockmaster.com/?a=f9

eGroup home: http://www.eGroups.com/list/ukha_d
Free Web-based e-mail groups by eGroups.com