Re: Good weekend :-)

["Powell Andy / AMS" <andy.powell@xxxxxxx>]

> My next project is to interface the doorbell to X10. I have an RF
doorbell
> with the ringer plugging in to the mains. Anyone go tany ideas as to
how
to
> send an X10 signal when the doorbell is pressed. I have a powerflash
module
> but the wireless door bell may no longer be wireless if i go that
route.
Any
> ideas greatly appreciated.

I'm not electrical wizz - in fact double check everything I say regarding
electricity!! but couldn't you un solder the connections to the 'buzzer'
and
attach the powerflash instead? so that when the doorbell is pressed it
causes contact on the powerflash and sends a signal over X10...

Would this work...anyone?

A.



*********************** DISCLAIMER ****************************
This message is intended only for use by the person
to whom it is addressed. It may contain information
that is privileged and confidential. Its content does
not constitute a formal commitment by Lombard Odier.
If you are not the intended recipient of this message,
kindly notify the sender immediately and destroy this
message. Thank you.
********************************************************************

--------------------------------------------------------------------<e-
Remember four years of good friends, bad clothes, explosive
chemistry experiments.
http://click.egroups.com/1/8013/9/_/2065/_/966853425/
--------------------------------------------------------------------e>-