The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: PCMCIA Advice?


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Supplier of CAT5 cable


  • To: "'ukha_d@xxxxxxx'" <ukha_d@xxxxxxx>
  • Subject: RE: Supplier of CAT5 cable
  • From: Williams Christopher C <CCWILLIAMS@xxxxxxx>
  • Date: Wed, 13 Sep 2000 14:17:30 +0100
  • Delivered-to: rich@xxxxxxx
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

-------------------------- eGroups Sponsor -------------------------~-~>
Need a credit card?
Instant Approval and 0% intro APR with Aria!
http://click.egroups.com/1/7101/9/_/2065/_/968872042/
---------------------------------------------------------------------_->

I think you can get special plastic trunking to lay in the floor.  The
top comes flush with the floor and can be removed for access.  I think
it is designed to take 2 15mm copper pipes.  No idea where to get it
though!

Cheers,

Chris Williams

> -----Original Message-----
> From:	Nigel Orr [SMTP:Nigel.Orr@xxxxxxx]
> Sent:	Thursday, September 07, 2000 3:04 PM
> To:	ukha_d@xxxxxxx
> Subject:	RE: [ukha_d] Supplier of CAT5 cable
>
> -------------------------- eGroups Sponsor
> -------------------------~-~>
> Special Offer-Earn 300 Points from MyPoints.com for trying @Backup
> Get automatic protection and access to your important computer files.
> Install today:
> http://click.egroups.com/1/6347/9/_/2065/_/968335391/
> ---------------------------------------------------------------------_
> ->
>
> At 13:19 07/09/00 +0100, you wrote:
> >be carefull, if the floor's sealed this might not be a very good
> idea, you
> >might be giving damp a way into the house.
>
> True, I think I've forgotten that caveat before.  Usually the sealant
> will
> be a DPM (dampproof membrane, usually some sort of plasticky rubber
> sheet)
> a few inches down, below the concrete slab, but if it's on the surface
> or
> within the depth of the channel, it will need to be reinstated
> afterwards.
>
> Remember that there is the potential to 'live life dangerously' and
> have
> the conduit very close to the surface, assuming it's all data wiring,
> so
> it's not _required_ to have the same degree of mechanical protection
> as
> mains cabling.
>
> However, you will regret it if you or a tradesperson later put other
> fixings into the floor or make holes in it and go into the conduit by
> mistake- you could mark the route on the concrete using paint, which
> should
> help avoid disaster, at least if the carpet is taken up before anyone
> drills or digs in future.
>
> Nigel
>
>
>


--
The Information contained in this E-Mail and any subsequent correspondence
is private and is intended solely for the intended recipient(s).
For those other than the recipient any disclosure, copying, distribution,
or any action taken or omitted to be taken in reliance on such information
is
prohibited and may be unlawful.





Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.