[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: Bathroom pullswitch to X10 compatible
- To: <ukha_d@xxxxxxx>
- Subject: RE: Bathroom pullswitch to X10 compatible
- From: "Kenneth Watt" <kennethwatt@xxxxxxx>
- Date: Fri, 6 Apr 2001 19:40:42 +0100
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
Mark,
I tried this with some success by using two appliance modules, one for halo
lights and one for the bathroom fan. I had to use a PIR and a door/window
contact switch on the door to let HV know that the door was closed as well
as someone being inside the loo, but it was a real pain to get it to work
properly the way I wanted!
K
-----Original Message-----
From: Mark Hetherington [mailto:markh@xxxxxxx]
Sent: 25 March 2001 23:31
To: ukha_d@xxxxxxx
Subject: [ukha_d] Bathroom pullswitch to X10 compatible
My bathroom currently has the "approved" pull switch for
lighting. I assume the conversion will require an xD10 module of
some form but what do I use to replace the switch itself or will
a pull switch work with an xD10 solution?
I require preset dim for nighttime visits which seems to suggest
an LD10(11 badged as 10) rather than AD10.
Ultimately I want to get a motion sensor (MS13?) which must
initially pick up the door as the motion to try and remove how
noticeable the X10 delay might be. However I also want the manual
backup for an interim solution until I get to motion sensing.
Thanks,
Mark.
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
Home |
Main Index |
Thread Index
|