RE: Home Vision Question

["Kenneth Watt" <kennethwatt@xxxxxxx>]

Geraint,

I too have been looking into this in a bit of depth.

I wanted to get the VisAccess
(http://www.letsautomate.com/10483.cfm?cfid=46892&cftoken=28318)
and use
that to send a signal to HV to open the doors and re-lock after a
pre-determined time. A bit more secure I think than solely relying on
X10!

HTH

K.

-----Original Message-----
From: geraint@xxxxxxx [mailto:geraint@xxxxxxx]

Sent: 07 August 2001 19:44
To: ukha_d@xxxxxxx
Subject: [ukha_d] Home Vision Question

Not got a homevision or even played/seen one.

I have just got the first of my electronic locks for the doors...

after all the messing around, I have left the standard five lever
mortice locks in, but have now purchased electromagnetic ones for
daytime convenience.

The circuit takes 12v (via transformer) to power the magnet, so I was
thinking the easiest way was to hook this into an Appliance Module,
wether plug in or Din Rail, so that I could switch off the circuit
thus allowing entrance.

Is there a way in Homevision to run a macro off a housecode ?

Then I could send an x10 signal to turn off the appliance module, but
then say 5 seconds later it would turn back on again, thus securing
the door.

Thoughts ? Other ways maybe ?

Regards

Geraint.





____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________

Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/



_________________________________________________________

Do You Yahoo!?

Get your free @yahoo.com address at http://mail.yahoo.com