[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: 2 Way
- To: <ukha_d@xxxxxxx>
- Subject: RE: 2 Way
- From: "Nigel friery" <nigel@xxxxxxx>
- Date: Fri, 16 Feb 2001 20:52:49 -0000
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
Thanks but a little confused
If I read it right
1) HV has the functionality to cope.
2) In Uk non "X10 manufactured" units can send a X10 command.
3) But X10 "manufactured" units cannot.
If I am correct where can I purchase controllers such as light switches
which do work ?
Thanks
Nigel
-----Original Message-----
From: Paul Miller [mailto:pmiller@xxxxxxx]
Sent: 16 February 2001 20:20
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] 2 Way
HV will listen for other devices sending a X10 command and then alter the
X10 status within HV to reflect the change.
BUT, in the UK only other controllers or motion detectors, keypads etc can
SEND a X10 command the standard units such as appliance modules, light
modules and light switches cannot send X10 commands hence they cannot show
they have been switched on by a local control.
-----Original Message-----
From: Nigel friery [mailto:nigel@xxxxxxx]
Sent: 16 February 2001 20:28
To: UKHA
Subject: [ukha_d] 2 Way
Does anyone know,
In a UK setup using Homevision and X10 units.
The Homevision spec states it "monitors" the X10 units for their
state
(on/off etc).
Is this still true for the UK spec X10 units.
Thanks
nigel
Home |
Main Index |
Thread Index
|