RE: Wiring party, anyone?

["Mark Harrison" <Mark.Harrison@xxxxxxx>]

Single spur, probably from the immersion heater spur.

The spur isn't for the loft, it's to come back down inside the wiring
cupboard, and really only power a switch.

The wiring cupboard is JUST for the patch panel/switch. Things link
Homevision and servers are going elsewhere.

Mark Harrison
Head of Systems, eKingfisher

************************************************************************
****
Kingfisher plc
Registered Office: North West House, 119 Marylebone Road, London NW1 5PX
Registered in England, Number 1664812

This e-mail is only intended for the person(s) to whom it is addressed
and
may contain confidential information.  Unless stated to the contrary,
any
opinions or comments are personal to the writer and do not represent the
official view of the company.  If you have received this e-mail in
error,
please notify us immediately by reply e-mail and then delete this
message
from your system.  Please do not copy it or use it for any purposes, or
disclose its contents to any other person.  Thank you for your
co-operation.
************************************************************************
****



-----Original Message-----
From: James Hoye [mailto:james.hoye@xxxxxxx]
Sent: 26 October 2001 13:44
To: ukha_d@xxxxxxx
Subject: Re: [ukha_d] Wiring party, anyone?


This email was delivered to you by The Free Internet.
http://www.thefreeinternet.net
---------------------------------------------------------------
> Some was to be square section with the clip on top for internal cables
> running through cupboards (round would also be fine but we need to
keep as
> much cabling hidden rather than conduited to surfaces plus it saves us
> buying the bending springs for the round stuff too) but to take the
cables

Already got 20 and 25mm bending springs :)
I ran some 50mm square stuff in Mark's node zero to tidy up  about 35
CAT5
cables - it took us almost a morning just to untangle and sort them
before
we could even consider starting to punch them down.

> from first to ground floor outside we were going to use the
rectangular
> section vent tubing as that will take the number of cables required
(sealed
> of course to prevent water getting in).
>
> One thing that we also do need to do is run mains supplies up into the
loft.

From...?  Via...?

One 16A spur enough, or do you want a 32A ring? (and not funny anal
jokes
here!)

James H



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/



_____________________________________________________________________
This message has been checked for all known viruses by the
MessageLabs Virus Scanning Service. For further information visit
http://www.messagelabs.com/stats.asp