|
The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024
|
Latest message you have seen: RE: Throw away VCRs |
[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
I thought I was going mad......
- To: "UKHA Discussion \(E-mail\)" <ukha_d@xxxxxxx>
- Subject: I thought I was going mad......
- From: "Keith Doxey" <lists.diyha@xxxxxxx>
- Date: Tue, 9 Apr 2002 09:25:05 +0100
- Delivered-to: ukha_archive@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
I thought I was going mad......
....when strange X10 things were happening or not happening.
No hot water the other day - BAD THING - Nearly froze my bits off in
the
bath
Thought the element must have died but tried an override of the module
-
water heated up OK -
- put that down to a 1 off X10 failure and considered changing the way
that
important things are done eg instead of turning the Water Heater OFF/ON
with
a schedule, have a flag that is set or cleared. Then have a scheduled
event
that happens every 10 minutes and either forces the Hot Water OFF/ON
according to the flag. That should mean it will never be wrong after 10
minutes even if a signal fails to get through. 10 minutes should ensure
I
dont flood the system with X10 traffic.
Couldnt turn the lounge lights off last night. - BAD SIGN
Tried a power down of the IR 543 - still no good.
Changed the house code and then put it back - still no good
Considered the X10 failure the other day - thought something was
blocking
it - waited 10 mins - it worked.
Alarm went off this morning but no light on in the bedroom - another
failure - BAD SIGN.
Came downstairs and went into the lounge - lamps were on like they
should
be - GOOD SIGN
5 seconds later - LAMPS WENT OFF - that aint supposed to happen - BAD
SIGN
Tried to turn them back on - IR543 not working - it sends directly to
the
lamps not via Homevision - BAD SIGN
Looked at the clock - 05:50 - DING !!!!!
Light SHOULD go off at 06:50
I had checked the time on Homevision and set it right when the clocks
changed but HV had then adjusted itself
1 HOUR FAST - RESET
Viewed the log to see what X10 commands it had received from the IR543
if
any....
LOADS, on housecodes A, P, J.... infact anything but L (Lounge)
Disassemble IR 543 - Code wheel broken - solder link in place - Now fixed
to
Housecode L
These are the first real problems I have had with X10 in over 5 years
and
the confusion was caused by 2 things
Wrong time on Homevision AND a faulty IR 543 at the same time.
Now what are the chances of that !!!!!!
I feel much better now normal operation has been restored :-))
Keith
www.diyha.co.uk
www.kat5.tv
Yahoo! Groups
Sponsor |
ADVERTISEMENT
|
|
|
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Home |
Main Index |
Thread Index
|
|