The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: ULTI questions


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [OT] Hardware problem...


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: [OT] Hardware problem...
  • From: "Anthony Livingstone" <anto@xxxxxxx>
  • Date: Sun, 4 Aug 2002 12:38:16 +0100
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Mark,

Personally I've never come across a PSU causing this type of problem but
it could be possible if the voltages are fluctuating.

Usual cause of this behaviour is over heating.
Having said that there could be a hundred other causes!
First thing I'd try is leaving the covers off the case and point a big
fan at it if you have one.
If this helps you can then look at increasing air flow over the CPU with
bigger heat sinks and more fans in the case.

If it's a modern board you should be able to see current temperature and
voltages and set overtemp alarms in the BIOS.
However temperature won't really rise until you stress the CPU by
booting the op sys.
Check the internet for H/W monitoring programs for your motherboard, if
you are quick enough you might be able to get one installed and monitor
temperature and voltages on screen.

A good stress test of how well your CPU is cooled is to run the
Seti@Home software which pushes the CPU to 100% constantly.
I have a couple of machines running this 24/7 which only work with the
covers off.
Saves on central heating.  :o)

Anto.

-----Original Message-----
From: Mark McCall [mailto:mark@xxxxxxx]
Sent: 04 August 2002 12:19
To: UKHA_D@xxxxxxx Subject: [ukha_d] [OT] Hardware problem...


I have a PC with intermittent hardware problem.  The CPU and main board
were supposedly replaced under warranty before I got hold of it but it's
still hanging.  I've tried replacing DIMMs and Graphics card.  Only
thing left is the PSU.  Can a dodgy PSU allow a machine to boot then
hang a few secs or mins later?

Are there any hardware testing proggys that fit on a floppy I could run?

Thanks

M


Yahoo! Groups Sponsor
ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.