|
The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024
|
Latest message you have seen: RE: Re: Cloud backup/archiving? |
[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Building Node0
- To: <ukha_d@xxxxxxx>
- Subject: Building Node0
- From: "Andy Laurence" <andy@xxxxxxx>
- Date: Fri, 27 Dec 2002 14:49:13 -0000
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
With my new job comes lots of holiday. This means I'm off work most
o=
f next
week (and this week). I plan to cable the house, and build my new
Nod=
e0.
Newey and Eyre do cheap CAT5 and coax, and have been good to me before.
Being the cheapskate I am, I'd rather not splash out on a proper rack
(=A32=
00
in the catalogue). I've seen posts from people who bought just the
st=
rips
down the side. Where can I get them, and are they significantly
cheap=
er?
Also, if anyone knows of somewhere I can get patch panels for less than
=A360/16 port, =A370/24, =A3110/32, =A3145/48 new or old, let me know.
As for the cabling, after cabling up a georgian house in the country
earlie=
r
this month (I will take photos when I go back - too busy this time), I
thin=
k
I can cope with my house. I'm fortunate enough to have a basement
and=
attic
to route cables through. Is there anything I should take note of
when=
doing
all this? Here's what I plan to run to each room...
Lounge:
4x CAT5 behind TV
1x coax behind TV
2x CAT5 to each corner beside sofas
Kitchen:
2x CAT5 to end cupboard
1x coax to end cupboard
1x CAT5 to work surface
Bedroom 1:
1x CAT5 above bed
1x CAT5 to TV
1x coax to TV
Bedroom 2:
none - easily accessible from loft at any time
Bedroom 3:
none - no autonmation planned in the medium term.
Bathroom:
none - not easy to get to, and nothing planned any time soon.
Does this look OK to people? I plan to have all my equipment in
node0=
,
distributed via coax now, and eventually KAT5. We have a TV in the
lo=
unge,
and bedroom 1, plus plan to have one in the kitchen. There is a
wirel=
ess
network in place for data. I plan to implement an IR distribution
sys=
tem
based from a server. I'm leaning towards FIRM, and Autom8it.
Wh=
en a good
looking X10 light switch is released, I'll use X10. I am severely
tem=
pted
to modify a standard light switch, though.
Any thoughts appreciated.
Andy (taping up knuckles)
http://www.automatedhome.co.uk=
a>
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Home |
Main Index |
Thread Index
|
|