|
Alan,
I
had
4 cameras and had the same problem with all of them. I sorted it
by:
Charging for 2 hours, keeping an eye to ensure the green light does
NOT
come on within the two hours, (if this happens lift the camera, and replace
on
the dock)
Use
the camera with the screen on, and flash, and keep snapping till the batts
are
flat, and the camera turns off.
Repeat
step 1.
This
SHOULD fix your problem. Like I said, it worked for all
mine.
The
red flashing light means:
|
Battery Pack is installed incorrectly. |
Reinstall the Battery Pack (Installing
the Battery Pack in the Camera). |
|
Incorrect battery type |
Charge only a rechargeable battery. |
|
The Battery Pack or connector pins are damaged. |
Check for damage. |
|
The camera and Battery Pack have been exposed to very high or low
temperatures. |
Slowly return the camera and Battery Pack to room
temperature. |
|
The EASYSHARE Camera Dock insert not properly installed. |
Insert the Dock insert correctly (Installing
the Dock Insert). |
I
found that its usually the last one. Try lifting and
re-seating. You
could also try removing and reinserting the battery
pack.
HTH
Stuart Whyte
Anyone having problems with their batteries, I
charged mine as instructed but they go flat after about 5 snaps, also what
does
it mean when the charge light flashes red.
Alancc
For
more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:
ukha_d-subscribe@xxxxxxx
Unsubscribe:
ukha_d-unsubscribe@xxxxxxx
List owner:
ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
|