The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Home Automator - WAS Re: HV MULTI ZONE RX UPDATE


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Sky Digital wiring woes



Have you checked for SHORTS.

Also check for strands of the screen, they often can make contact with the
centre conductor.

One further possible cause, I assume you are using F Connectors, have you
cut the centre wire too short so that it doesnt make contact with the
socket.

Keith



-----Original Message-----
From: bquinn123456 [mailto:bquinn@xxxxxxx]
Sent: 19 June 2002 19:14
To: ukha_d@xxxxxxx
Subject: [ukha_d] Sky Digital wiring woes


Hi Folks,
Can't seem to get the digibox to get a signal from the satellite
using my in house wiring set-up.

Here's the scenario:

Cable runs from Satellite into the attic where it is joined with
another cable which leads into my wiring closet. That wire then
attaches to one which runs into the sitting room wall outlet. This is
then patched into the digibox... no signal?

Tried connecting the digibox into the cable in the wiring closet...
no signal!!

I dragged the digibox and TV into the attic (not an easy job) and
connected to the cable coming from the dish... that worked fine.

I have tested the cable run from attic to sitting room and I am
getting continuity!!

Any ideas?... could interference from somewhere be causing a problem?


Cheers,

Brian Q



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/




Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.