The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: More Serial Ports needed


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Speakers for announcements


  • To: ukha_d@xxxxxxx
  • Subject: Re: Speakers for announcements
  • From: "psghome2002" <psghome@xxxxxxx>
  • Date: Sat, 13 Jul 2002 17:38:16 -0000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

That's a pretty small speaker requirement then! How about putting
them in the ceiling - I've got 7 sets of ceiling speakers in various
rooms. They sound great and look very good (probably less obvious
than wall speakers). I went for a variety of models including:

Sonance GRM2 - Single stereo to mono summing speaker (water
resistant) - for use in the bathroom =A390 ish

Systemline QED - Stereo pair for general areas =A3130 ish

Sonance 621 - Good quality stereo pair for listening rooms =A3240 ish

Also used 79 stand OFC cable

May be OTT for your requirements (whole lot cost over =A31000 - cheap
compared to what you can easily spend). My system was primarily a
whole-house audio system with feeds for Comfort, ACE TTS etc.

Paul.


--- In ukha_d@y..., "Nikola Kasic" <nikola@k...> wrote:
> The time has come...
> I am ready to put some more cable throughout the flat. I
downloaded homeseer
> yesterday, for a trial and saw that I should really have some
speakers for
> announcements.
> Inital plan is to put small wall speaker in each room (5+2,
kitchen, lounge,
> hallway, 2 bedrooms + 2 bathrooms).
> I plan to put them above the doors in each room. Bathroom ones
must be water
> resistant. Internal walls are very thin, 5 cm including plaster on both
> sides. Plaster is about 12mm, so I have just 38mm from surface to
the back
> of the plaster on the other side of the wall.
> Did anyone see such a thin speakers, preferrably in white.
> Are there any standards in speaker sizes, so if speaker dies at
some point
> later I'll have no problems replacing it? I don't want some funny
shapes, so
> I have problems finding spare later.
> And, most important question: What kind of cable to put for that
speaker?
> I suppose hi-fi speaker cable should be fine, but are they an
overkill?
> Also, because it's crossing power lines, wouldn't it be better if
it's
> shielded? Also, they are thick, generally speaking, should I go for > something thinner?
> Please come with your experiences, because once I put it in, it
will be
> impossible to replace it later.
> Cheers,
> Nik


Yahoo! Groups Spons= or
3D"Click 3D"Click 3D"Avucue2 3D"ACUVUE 3D"FreshLoo= 3D"Focus 3D"Get
Click here to find your contact lenses!

For more information: http://www= .automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.