The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: web software (Front Page)


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Perimeter Security Lighting - Dedicated or Comfort Controller?


  • To: <ukha_d@xxxxxxx>
  • Subject: Re: Perimeter Security Lighting - Dedicated or Comfort Controller?
  • From: "Richard Challis" <richard@xxxxxxx>
  • Date: Thu, 14 Mar 2002 16:10:34 -0000
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • References: <a6qdla+p6jf@xxxxxxx>
  • Reply-to: ukha_d@xxxxxxx

I currently use the GJD opal PIR sensors wired back to my Homevision.
The exterior floods are controlled via some LM12U's admittly I probably
should be using the din rail mounted units or SSR's but I had a shedload of
these units after a spending spree at Homebase when they were selling them
off for silly money!

The HV also will control the CCTV when I finish putting the cameras up.

The only cool thing about using a lamp module, is that I can go for full on
when required and then dim gradually after the timeout. Not much practical
use, but it looks somewhat different and unusual from the normal PIR
lighting.

Regards

Richard


----- Original Message -----
From: "tomdubourg" <thomas.dubourg@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Thursday, March 14, 2002 2:55 PM
Subject: [ukha_d] Perimeter Security Lighting - Dedicated or Comfort
Controller?


> Hi all
>
> I was reading the thread earlier about the GJD exterior PIR sensors
> for lighting control.
>
> I'm planning an exterior lighting systen with the following
> requirements :-
>
> -After dark PIR detection (3 zones)
> -Manual over ride
> -Audiable alert for some PIR zones
> -Lighting switching for 3 zones
>
> My plan is for the following setup all controlled by Comfort :
>
> GJD PIR sensors -Wired to- Comfort alarm panel
> Exterior Halogens -Wired to- DIN X10 module to MAINS
>
> On looking at the GJD website I see they do dedicated lighting
> controllers - specifically the Solitaire (4 Zone model).
>
> Questions :
>
> -Will Comfort meet my lighting controlling requirements?
> -Would switching the lights via X10 cause a noticable extra delay
> between detection and switching?
> -Would using a dedicated lighting controller like the GJD Solitaire
> be a better solution?
>
> Any thoughts/issues/answers will be gratefully received before I open
> the wallet!
>
> Thanks
>
> Tom
>
>
>
>
>
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>



Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.