Re: LM15

[ian.bird@xxxxxxx]

> Can some explain what this 'All lights on' command actually does?

There are two of these commands. All lights on and all units off. The
former only affects lamp modules and LD11 rail units etc. and turns
them
ON. The latter will turn everything OFF be it a lamp or appliance
module
variety. They are both House Code dependent so either sent to A will
only
affect A and NOT B - E. All unit numbers on the house code in question
are
affected e.g. A1 to A15. This means your module is at least on house
code
A.

> How do I identify the code of the lamp?

Not knowing the module in question I would suggest trial and error. You
have already done it A2 so only 15 to go. I would start at A1 as this
is
the most common default.

HTH

Ian



http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.