RE: IRM +FirM Interfacing Update

["Nikola Kasic" <nikola@xxxxxxx>]

Frank, if I understand properly, with IRM and FirM you can use PC
(Autom8it)
as a brain and control where the commands will be transmitted. That way
IR
commands will not be sent through the whole house, but to the
pre-programed
zones only. Also, we don't need a HV for controling FirM, but can use
PC.
Can you tell me am I right?
Cheers,
Nik
  -----Original Message-----
  From: Frank Mc Alinden [mailto:armagh@xxxxxxx]
  Sent: 22 October 2002 12:38
  To: ukha_d@xxxxxxx
  Subject: [ukha_d] IRM +FirM Interfacing Update


  HI all
          Just a quick update
on were Dan and I are at with Dans IRM and my
FirM....

  Well at the moment Using Dans software the pc can send a tx zone
command
to the FirM Interface and select a tx zone on firm.......Also when an
ir
signal is received by Dans software it asks the interface for zone id
and
displays it on the pc........At this point im trying to get my ir sytem
(firm + hv) to respond to a txed ir signal with little luck not sure if
its
a hardware problem????

  More Soon

  Frank

  [Non-text portions of this message have been removed]


        Yahoo! Groups Sponsor
             
ADVERTISEMENT





  http://www.automatedhome.co.uk
  Post message: ukha_d@xxxxxxx
  Subscribe:  ukha_d-subscribe@xxxxxxx
  Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
  List owner:  ukha_d-owner@xxxxxxx
  List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

  Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.



[Non-text portions of this message have been removed]

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.