[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: Recommendation for pulling lighting cable for X10 enablement
{Scanned for Viruses}
This might sound strange but, Microbore pipe... we had a lot left over
>from
cables... bends easily but still very strong.... when it's where you
want it, pull some string through and use that to feed the cables.
This method has been used for 8 runs of Cat5, and two mains to avoid
lifting our floor (floorboards, with plywood nailed on top about 30
nails per sheet!!!)
Ross
--
Ross McKillop
On 3 Dec 2003, at 20:40, Gareth Cook wrote:
> Just a quick Q - I'm helping a chum install some low voltage lighting,
> and
> we need to cut the holes, and pull the cable through without taking
> down
> the ceiling nor pulling up the floorboards above.
>
> I would assume we need some sort of sturdy wire/conduit of some kind
to
> feed the cable parallel to the floorboards. Anyone done this ?
>
> G.
--
This message has been scanned for viruses and
dangerous content and is believed to be clean
Home |
Main Index |
Thread Index
|