RE: Lighting disaster in new build :-(

["ben addison" <ben@xxxxxxx>]

Try www.metalspot.it then under search select lighting source.

It will then list there 230v wire system, I used it of a bar I did in
Italy last year. You can order part from direct. I get 15% ish off there
price, and will be driving over there next month so if needs be could
order and pick them up for you.

HTH

Ben Addison
Electrical Contractor
Tel 01924 430767
Mob 07889 845712




-----Original Message-----
From: big_red_frog [mailto:anthony.tod@xxxxxxx]
Sent: 11 December 2003 16:52
To: ukha_d@xxxxxxx
Subject: [ukha_d] Lighting disaster in new build :-(

Hi All,

Those of you on the self build group would of seen this thread
already.

But basically I am in the middle of a conversion where I had wired
for flush mount mains GU10's in the ceiling, with X10 din rail mount
dimmers in the garage on four seperate runs to control it all.

Now I find I can't put the flush mounts in, and need something
external due to ventilation, vapour barrier, etc, etc.

One option is wire mounted spots, where they run between two wires,
look quite tech, but I can only find the low voltage version of
these at the moment, though I know there is a mains version with
trick wiring, just can't find it.

Does anyone know if the X10 dimmers will run with any low voltage
lights, wether transformer or switch mode.

Any other ideas?



UKHA 2004: 15th and 16th May 2004

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/