RE: Local IR Distribution

["Darryl Mattocks" <Darryl.Mattocks@xxxxxxx>]

I've been using Powermids for quite a time without any problems, and
continue to do so.  The Plasma generated so much interference that it
stopped them working downstairs and so for the room with the Plasma in I
use a hardwired solution
(http://www.simplyautomate.com/productDisplay.asp?prodId=3774
) but
upstairs, they are fine.





Regards

Darryl.



Simply Automate - Bringing your home to life.



http://www.SimplyAutomate.com/

mailto:Darryl.Mattocks@xxxxxxx

Tel: 01865 784 080

Fax: 01865 784 081





-----Original Message-----
From: Ant [mailto:ant@xxxxxxx]
Sent: 18 July 2003 11:38
To: ukha_d@xxxxxxx
Subject: Re: [ukha_d] Local IR Distribution



On Friday 18 July 2003 11:14, Hawes,Timothy Edward (GEG) wrote:

> For a pre-built solution you may want to look at Powermids (no
personal
> experience), or these (ditto): http://www.smarthome.com/8225.html

The Powermid setup is a cheap and viciously effective broadband
infra-red
jammer. However for the purpose of distributing IR signals, it's about
as
much use as tits on a boar. You can simulate the effect of owning and
operating them without the outlay by simply a) repeatedly punching
yourself
in the face and then b) spending your whole life running up and down
stairs.

ant
--
/\/\
www.ant.org  ('')  www.ant.org
()
Megawatt Winged Avenger