[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: FirM
>From memory (since I'm in USA at the moment) it's >about 3 inches
square.
>Depth varies, with the deepest box being about 75mm >IIRC. For the
Xantech
>stuff, I believe you need to cut the back off the >box to make it
deeper than
>that though. What sort of depth would be required >for anything you
produced?
The current board is approx just under 3" long by 2" wide.....But
has the rj45 at one end and the ir receiver at the other.....I have had the
board modded so the ir receiver can be put in the middle so it can be used
with a plate....The height of the highest component would be approx
15mm..The rj45 would have to be a vertical version i would imagine ...so a
rj45 plug would have to be crimped onto the cat5 cable ....
Frank
[Non-text portions of this message have been removed]
- References:
- FirM
- From: "Frank Mc Alinden"
<fmcalind@xxxxxxx>
- Re: FirM
- From: "Paul Robinson"
<ukcueman@xxxxxxx>
- Re: FirM
- From: Frank Mc Alinden
<fmcalind@xxxxxxx>
- Re: FirM
- From: "Paul Robinson"
<ukcueman@xxxxxxx>
Home |
Main Index |
Thread Index
|