RE: Re: X10 Curtain Controller for Autoglide/Swish!

["Paul Gale" <groups@xxxxxxx>]

If you've got the cheaper (non programmable) version of the Autoglide
controller, it supports discreet open/close commands straight out of the
box by using the correct pins on the RJ11 connector (there are two on the
motor housing). I use a relay driven by Comfort to close the correct
terminals (one for open, one for close). Works a treat - I have the
curtains opening and closing via a HV schedule (linked to Comfort) and also
on security mode changes i.e. away mode closes the curtains etc. You can
also use HV to do the same thing.

Great stuff!

Paul.



-----Original Message-----
From: paul_watkin [mailto:paul_watkin@xxxxxxx]
Sent: 03 November 2003 16:23
To: ukha_d@xxxxxxx
Subject: [ukha_d] Re: X10 Curtain Controller for Autoglide/Swish!

did anyone ever get anywhere implementing anything similar that could
be hard wired to say comfort which would allow disrete open close etc?

Or can it be done by adding a relay in parallel to the existing
switch and controlling that via short pulses from Comfort or
Homevision

Paul

--- In ukha_d@xxxxxxx, "Mark McCall" <lists@a...> wrote:
> Laser have developed in house an X10 controller for the popular
motorised
> curtain rails from AutoGlide. They are compatible with the Swish
K400 as
> well...
>
> http://www.automatedhome.co.uk/article.php3?story_id=1318
>
> M.



UKHA 2004: 15th and 16th May 2004

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/