Re: SW10G help required

["big_red_frog" <anthony.tod@xxxxxxxxx>]

I was, but the knowledge that there was a package from
letsautomate.com sitting on my doorstep proved an irristable draw,
and of course saying hello to SWMBO, so now I have to drive back to
Birmingham in the morning :-(

--- In ukha_d@xxxxxxx, "UKHA" <mailinglists@v...> wrote:
> Hang on a minute... I thought you were stuck in a hotel room?  :/
>
>   -----Original Message-----
>   From: big_red_frog [mailto:anthony.tod@z...]
>   Sent: 11 August 2004 19:21
>   To: ukha_d@xxxxxxx
>   Subject: [ukha_d] SW10G help required
>
>
>   Hi All,
>
>   I must be having a dull day...
>
>   I am having desperate trouble with an SW10G I have just recieved.
>
>   I am using this to control my projector screen.
>
>   It is correctly wired up to give up and down control as you would
>   expect and one touch start, stop, and hold in control works fine.
>
>   However, I can't seem to program the automatic open and close
time
>   correctly.
>
>   The instructions are written for window blind use, and they are
none
>   too clear or dependable!
>
>   As far as I can see I have to start with the projector screen
>   closed, as in fully rolled up.
>
>   Switch to teach mode by placing the house code to *
>
>   Then press the down button once. When the screen is at the
desired
>   height, press the down button again and the screen stops.
>
>   Then switch to the desired house code and everything should be
OK.
>
>   I assume that to close the screen it just runs this time + a bit
to
>   allow it to hit the stops, as you can't guarantee that the open
and
>   close speed are the same.
>
>   Anyway, my problem is that it just doesn't seem to care what I
>   attempt to program as the screen open time, when I send it X10
>   commands, it just runs on until the screen hits the physical open
>   stop.
>
>   Any ideas guys, anyone else used one of these and can tell me
what
>   the obvious thing I have missed is please?
>
>   Yours in desperation...
>
>
>
>
>
>
>
>         Yahoo! Groups Sponsor
>               ADVERTISEMENT
>
>
>
>
>
> -------------------------------------------------------------------
---------
> --
>   Yahoo! Groups Links
>
>     a.. To visit your group on the web, go to:
>     http://groups.yahoo.com/group/ukha_d/
>
>     b.. To unsubscribe from this group, send an email to:
>     ukha_d-unsubscribe@xxxxxxx
>
>     c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms
of Service.
>
>
>
> [Non-text portions of this message have been removed]