RE: [OT] Corner (90 degree) plastic trunking...

["Kilgore, Andrew" <amkilgore@xxxxxxxxxxxx>]

Tim,

Yeah I was hoping for something triangular in cross-section.
I've not seen any either but I figure _someone_ must make something like
it...???

Thanks,
Andy.

-----Original Message-----
From: Hawes,Timothy Edward (GEG) [mailto:haweste@xxxxxxx]
Sent: 13 February 2004 12:56
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] [OT] Corner (90 degree) plastic trunking...


> -----Original Message-----
> From: Kilgore, Andrew  Sent: 13 February 2004 10:20
>
> Hi all,
>
> Does anyone know where I can find some plastic corner
> trunking (to run up
> the corner of a wall).
> Tried my usual haunts but no luck there...
> Looking for something about 7cm long on both sides.
>
> Failing that, anyone done something like this themselves...?
>
> Many thanks,
> Andy.

Andy,

Not quite sure what you're after - something like this ?
http://www.tlc-direct.co.uk/Main_Index/Trunking_Pvc_Index/Maxi_3/index.html
<http://www.tlc-direct.co.uk/Main_Index/Trunking_Pvc_Index/Maxi_3/index.html
>
(75mm square)

Or do you mean something triangular in cross-section ? Never seen that
though :-(

HTH,

Tim H.


+


UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com <http://www.ukha2004.com>

http://www.automatedhome.co.uk
<http://www.automatedhome.co.uk>
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx