The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: GrandDesigns 5


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Fw: Now [OT] SDSL was Re: WOOOOOOOOO HOOOOOOO!!!!



cause if youre ethernet you have already got an ip - MLPPP works below
that layer

if you have two ethernet routers then the windows box will be presented
with 2 IPs - and then you can only load balance.

G.

Gareth Cook
SWG EMEA North Account Manager
IBM SWG - BTE Office - Lotus Park, Staines, TW18 3AG
Office: +44 (0)1784 445166 - Mobile: +44 (0)7980 445166
AIM Chat : TheBoyG - MSN Chat : chat@xxxxxxx
email: g@xxxxxxx


----- Forwarded by Gareth Cook/UK/IBM on 18/02/2004 22:33 -----

Discussion
Main Topic

Ho Yin Ng <yahoogroups@xxxxxxx>
Today 21:37

.
Subject:
.
Re: Fw: [ukha_d] Now [OT] SDSL  was Re: WOOOOOOOOO HOOOOOOO!!!!
.
Category:



Apparently AA can alllow you to have up to 5 ...

10mb down!!! hurrah ... for that money i think I would move though to an
office in Sweden where you can get a T3 line.

Linux huh .. god the last time I tried to install Linux on a spare machine

I failed miserably ... I am now too scared to even contemplate it.

Can I not do the same thing in windoze? Does it have to be USB modems? Why

not ethernet?

Ho Yin

At 21:30 18/02/2004, you wrote:
>it's good enough for me !
>
>nildram have the cisco kit at their end to support MLPPP. They will do
4
x
>DSL lines. So you could have 4 x 2Mb, 8Mb down, 1Mb up
>
>G.




UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.