RE: Re: RJ45 to BT Converters needed !

["Jon Whiten" <jon@xxxxxxxxxxxx>]

As there are 2 standards for wiring Cat5 cable (568A and 568B), see below,
could it be that your standard CAT5 wiring is to one standard and the
adaptors you are using are to another?

If so, and assuming you have punched down all 1 circuits at your patch bay,
try connecting the Green/White terminal from you patch bay to pin
3(Orange/White) at your NTE5 point.


EIA/TIA 568B
WIRING STANDARD
PIN
Wire Color
1 White w/Orange Stripe
2 Orange w/White Stripe
3 White w/Green Stripe
4 Blue w/White Stripe
5 White w/Blue Stripe
6 Green w/White Stripe
7 White w/Brown Stripe
8 Brown w/White Stripe

(EIA/TIA 568A)
PIN
Wire Color
1 White w/Green Stripe
2 Green w/White Stripe
3 White w/Orange Stripe
4 Blue w/White Stripe
5 White w/Blue Stripe
6 Orange w/White Stripe
7 White w/Brown Stripe
8 Brown w/White Stripe


Regards

Jon Whiten
http://www.whiten.co.uk
-----Original Message-----
From: Gareth Cook [mailto:g@xxxxxxx]
Sent: Wednesday, November 17, 2004 1:04 PM
To: ukha_d@xxxxxxx
Subject: Fw: [ukha_d] Re: RJ45 to BT Converters needed !


Patrick

Those are PABX not PSTN adators.

Mebe I have it wired wrong at the master socket ? As the NTE5 socket (the
incoming feed) I have the following wired to the patch panel :

2 - Blue/White
3 - Orange/White
5 - White/Blue

Then the patch panel is wired in series to the other sockets. I can take
all
other connections off so I have one phone plugged in. If I use a secondary
pbx socet, it's all fine - except the phone doesnt ring. If I plug in a
master into another socket (with no phone in it) the phone rings. but I get
echo.

:-(

G.

Gareth Cook
SWG EMEA North Account Manager
IBM SWG - BTE Office - Lotus Park, Staines, TW18 3AG
Office: +44 (0)1784 445166 - Mobile: +44 (0)7980 445166
AIM Chat : TheBoyG - MSN Chat : chat@xxxxxxx
email: g@xxxxxxx