The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: Re: Linksys WAP11 Ver 2.2 in Bridge Mode (802.11b)


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: Re: Linksys WAP11 Ver 2.2 in Bridge Mode (802.11b)


  • Subject: RE: Re: Linksys WAP11 Ver 2.2 in Bridge Mode (802.11b)
  • From: "Hawes,Timothy Edward \(GEG\)" <haweste@xxxxxxxxxxxxxxx>
  • Date: Wed, 6 Oct 2004 15:19:39 +0100


> -----Original Message-----
> From: Andy Laurence  Sent: 06 October 2004 15:00
>
> From: Hawes,Timothy Edward (GEG) [mailto:haweste@xxxxxxx]
> > The MAC filter table would also provide some security in lieu of
> > disabling WEP, if that too actually works though.
>
> The MAC filter is a far more effective security feature than
> WEP.  WEP is easily cracked with software freely available on
> the 'net using any wireless card in a laptop.  Spoofing a MAC
> address is a much harder nut to crack.  If you want security
> on a wireless network, treat it as you would the Internet.
> This means VPN into your wired network, and/or use publically
> safe services on the network.  My setup is completely 100%
> open (by design), but looking at the logs, nobody ever
> actually connects.  That's in a busy suburb in Bristol.

Andy,

Thanks. My comment was more directed towards "I know the WAP11 *says*
it
supports MAC filters, but does it really ?" (like it says it also
supports bridging, and it does, apparently, after a fashion :-/ ).

It'd be nice to get it to do WPA too, but I think that'll be pushing it
a bit for this older model.

Nice to know MAC filters are reasonably secure though.

Thanks again,

Tim.
:-)

+



UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.