The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: 1-Wire Headache


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: DVI Cabling advice needed


  • Subject: Re: DVI Cabling advice needed
  • From: "darren_karp2001" <darren@xxxxxxxxx>
  • Date: Sun, 09 Jan 2005 18:06:46 -0000



Hi Keith and thanks for the reply. Not so sure I know what you are
referring to with regards to the mirroring. If you think about it
all I'm trying to do is extend my existing dvi cable with a coupler.
However, the coupler needs to fit onto a faceplate and the rear part
needs to be at right angles.

Cheers
Darren

--- In ukha_d@xxxxxxx, "Keith Doxey" <ukha@d...> wrote:
> Hi Darren
>
> I think you will be unlikely to find what you need as the two back
to back
> sockets would need cross wiring as they would mirror each other
>
> eg
>
> Socket 12345
>        54321
>
> so whatever you found (if anything) would be quite bulky.
>
> Could you get two wireable sockets and connect them with very
short wires,
> that way one could be fixed to the faceplate and the other plugged
onto the
> cable and your 90 degree problem is solved.
>
> Keith
>
> > -----Original Message-----
> > From: darren_karp2001 [mailto:darren@a...]
> > Sent: 09 January 2005 17:22
> > To: ukha_d@xxxxxxx
> > Subject: [ukha_d] DVI Cabling advice needed
> >
> >
> >
> >
> >
> > Hi All,
> >
> > I need to run my 10m M1-DA - DVI cable from my MCE box to my
> > projector. The route will go from one end of my living room near
the
> > floor, up and across to where the projector will be hung on the
> > ceiling. The problem is that as I'm trying to keep all my cables
as
> > neat as possible I really wanted to be able to plug my MCE box
into
> > a DVI socket mounted on a face plate in the wall using a short
DVI -
> > DVI cable. What I'm looking for and can't seem to find is a
chassis
> > mounting DVI socket which has female connections both sides and
can
> > be mounted onto a standard UK face plate. The other problem
> > associated with this is that the DVI plug on my cable is moudled
and
> > approx 2 inches long so any chassis socket would need to be
right-
> > angled.
> >
> > Can anyone advise? I really don't want to have to have a cable
> > poking though the wall or floor.
> >
> > TIA
> > Darren
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
> >
> >
> >






UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.