RE: X10 Question

["Nigel Giddings" <nigel@xxxxxxxxxxxxxx>]

Jonathan,



I wouldn't add as part of the '2-way' as it might have the opposite
effect you require.



That is to say it would turn off the light that was on should an alarm
occur.



A straightforward on/off switch that over-rides the switching so that
the light is switched on no matter what the switch status...



Any of the Lamp modules or even a switch module would achieve this. I
would suggest a Din Rail mounted switch rather than a dimming lamp
module.



HTH



Nigel



-----Original Message-----
From: Jonathan Hall [mailto:jonathan@xxxxxxx]
Sent: 18 August 2006 10:32
To: ukha_d@xxxxxxx
Subject: [ukha_d] X10 Question



HI folks,

My burglar alarm has a X10 interface, I would like to able to switch on
the
landing and hallway lights if an intruder or fire is detected, my alarm
can
support smoke detectors as well.

So my question, is there an X10 module that would act like a 2 way or
intermediate switch that I could add to the essentially traditional
wiring
in the house? It is all being rewired at the moment so putting it in now
can be done when the wiring for this light circuit goes in.

Cheers

Jonathan

[Non-text portions of this message have been removed]




------oooo0oooo-------
18/8/2006



[Non-text portions of this message have been removed]