Re: [ADVERT] Internet enabled Central heating controller with 1 wire space temp

["ukhauk" <jasonstarkie@xxxxxxxxxxxx>]

The program at the moment is only configured for one zone and one
temp sensor, but it shouldn't be a problem to change this and add
multiple zones the only limitaion is the number of outputs on the
barionet (2 built in relay outputs volt free and 4 open collector
outputs 24 volt DC 0.1 amp which could drive additional relays) so
six zones.

A frost protection setpoint has already been built in to the software
so that should the space temp fall below say 10 deg C the heating
will be enabled.

Another useful addition might be to monitor the outside temp and
disable the heating if the outside air temp is above say 23 deg C.

Any thoughts or comments'

Jason


--- In ukha_d@xxxxxxx, Kevin Hawkins <lists@u...> wrote:
>
> ukhauk wrote:
> > Additional 1 wire temp sensors can be connected to the Barionet
so
> > you can monitor the temp in various rooms or even outside temp.
> >
> In this scenario would the controller calculate individual
> characteristics for each individual sensor (room) and can you have
> different times/setpoints for each  ? If so yes, very interested...
> >
> >
> >
> > Any thoughts or comments'
> >
> > Jason
> >
> >
>
> Kevin
>