Greetings, and a question

["Andy Gilliatt" <andy@xxxxxxxxxxxx>]

Good Morning,

This is my first post, and will definately not be my last. I currently run
a
few X10 modules around the house for lamps, and control these using
Stick-switches, and the CM12 unit together with Activehome. I intend to
expand the X10 control over the next few months, adding motion detectors,
CCTV and alarm.

I have recently replaced my CRT TV with a plasma, and hooked it up to SKY+,
Media PC and XBOX (running XBMC) and AV receiver. I am controlling all of
this using a Harmony 895, with the RF extender, as everything bar the
plasma
is located in my office. I would like to control the X10 modules using th
895 but am struggling. I have purchased the IR7243RF unit, and added this
to
my list of devices on the Harmony. The problem appears to be that this
device lists LIGHTS ON/OFF DIM etc, but my lamps are actually controlled by
X10 appliance modules, not lamp modules, and the Harmony is not switching
them on.

Does anybody else have a similar setup, or maybe tell me where I am going
wrong.

Thanks in anticipation, and I look forward to becoming an active member of
this group,

AndyG


[Non-text portions of this message have been removed]






** Sponsored by www.BERBLE.com **
all the Cool Stuff, in one Place