[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Re: ESD matting
White, Peter wrote:
> Good spot, bit narrow though, we'd need 600mm deep (42 x 1.8mtr
benches)
>
You might want to consider putting new dissipative tops on rather than
fixing the matting to the existing ones. Note if they are benches with
an equipment rack above then these should probably be done as well. The
old Modulux benches that were fairly standard fit in labs had the main
bench as ESD but not the shelf above (well the ones where I used to work
didn't). I'm not sure if Modulux are still operating but there number is
(or was) 01252 26277.
Laurence
UKHA_D Main Index |
UKHA_D Thread Index |
UKHA_D Home |
Archives Home
|