RE: CBus wiring

["Nigel Giddings" <nigel@xxxxxxxxxxxxxx>]

Paul,

When I was designing my C-Bus install I too planned to use Aux Inputs. I
went a step further and was going to have different switches in different
places in the same room connected to the same Aux Input input. Looking at
the design I wanted some switches to do exactly the same thing, for example
all lights off, so I was going to connect both locations to the same input.

Hope this makes sense?

I have now decided not to install C-Bus (is that heresy?) but have started
installing Helvar instead.

Nigel


-----Original Message-----
From: Paul Gale [mailto:groups2@xxxxxxx]
Sent: 27 February 2007 22:44
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] CBus wiring

Thinking more about it - The aux inputs may be best as I have a lot of
single switches - these can all run back to a number of Aux Inputs yes???
Saving a fair bit of cost...

Paul.



> -----Original Message-----
> From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf
> Of Phil Harris
> Sent: 27 February 2007 22:39
> To: ukha_d@xxxxxxx
> Subject: RE: [ukha_d] CBus wiring
>
>
> > Thanks Phil - ah yes I remember now.
> >
> > So what are the options where I can't really run any new cable to
a
> > switch?
> >
> > Paul.
>
> Well, after re-reading your email I guess you're looking at putting
the
> bus
> coupler in behind the switch and running C-Bus back across the
existing
> T&E,
> is that correct?
>
> If so then the chances are that C-Bus will run just fine across
T&E but
> of
> course I can hardly suggest that you do do this can I?
>
> Phil
>
>
>
>
>
>
>







--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 268.18.4/703 - Release Date: 26/02/2007
14:56


--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 268.18.4/705 - Release Date: 27/02/2007
15:24