RE: Re: Fuse has blown inmy Pioneer plasma PSU

["Dean Barrett" <dean@xxxxxxxxx>]

Mine was just under 5 years....




Dean.

-----Original Message-----
From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Darren Karp
Sent: 22 November 2007 16:23
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] Re: Fuse has blown inmy Pioneer plasma PSU

Thanks Dean but I seriously doubt that even Pioneer or their agents will
replace a 7 year old PCB. If I can't find an electronics engineer who can
repair the board then I'm screwed!

_____

From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Dean Barrett
Sent: 22 November 2007 15:16
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] Re: Fuse has blown inmy Pioneer plasma PSU



I believe this is the known PSU problem with Pioneer units my 434 failed
exactly the same and it was replaced FOC well out of warranty.

Pioneer support are not very forthcoming - ring them up ask for a local
repairer - my repairer immediately confirmed it was FOC replacement.

Do a Google for Pioneer Plasma problems - its bound to come up.

Dean.

-----Original Message-----
From: ukha_d@yahoogroups. <mailto:ukha_d%40yahoogroups.com>
com
[mailto:ukha_d@yahoogroups. <mailto:ukha_d%40yahoogroups.com>
com] On Behalf
Of
darren_karp2001
Sent: 22 November 2007 14:30
To: ukha_d@yahoogroups. <mailto:ukha_d%40yahoogroups.com>
com
Subject: [ukha_d] Re: Fuse has blown inmy Pioneer plasma PSU

--- In ukha_d@yahoogroups. <mailto:ukha_d%40yahoogroups.com>
com, "Slavo"
<slavo@...> wrote:
>
> Darren,
>
> you need to replace the fuse with one that has the same current
> characteristics. Inrush current is what you get when you switch
some
> appliances on. Current can be several times the rated amount (but only
> for short period) so if you replaced it with ordinary one you may blow
> it again first time you switch it on. The current curve
for
> your fuse is defined here.
>
> http://www.socfuse.
<http://www.socfuse.co.jp/SOCcatalogE/Page45.pdf>
co.jp/SOCcatalogE/Page45.pdf
>
> Slavo
>
Thanks.

I spoke with their European headoffice today and a very nice chap managed
to
find me an RS part which I fitted.

Now the problem is although the plasma goes into standby which it didn't
yesterday when I switch it on the power led goes green and 3 or so seconds
later I hear a relay click and goes back into standby.

So, what I need now is an electronics engineer that can test the PSU board.

Any offers?

Cheers
Darren






[Non-text portions of this message have been removed]