RE: Re: Water flow sensors?

["Paul Gale" <groups2@xxxxxxxxxxxxxxxx>]

Thanks Steve :)

- I have seen those before BUT the reason I was asking is because I wasn't=
sure if they're recommended for connecting into a domestic hot water suppl=
y - would there be problems with them reducing flow etc and can they be
eas=
ily connected with push fit and/or copper compression fittings etc etc?

Cheers,

Paul.



> -----Original Message-----
> From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf
> Of Steve Morgan
> Sent: 24 October 2007 10:01
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] Re: Water flow sensors?
>=20
> --- In ukha_d@xxxxxxx, "Paul Gale" <groups2@...>
wrote:
> >
> > Can anyone recommend a cost effective DHW water flow sensor? i.e.
> not a =A3100 each RS part! ;)
> >
> > As my replacement heating system is going in, I want to fit 3 x
> water flow sensors in 15mm plastic (JG speedfit) to the supplies to
> the hot feed on 3 x showers. The contacts need to be simple no-volt
> contacts that will then feed into HomeVision. This will allow me to
> do some clever stuff like turning on fans and electric mirror heaters
> etc.
> >
>=20
> Searching for "Flow Switch" turns up four on CPC's site:
>=20
> http://cpc.farnell.com/jsp/search/browse.jsp?
>
N=3D411+500001+1002819&Ntk=3Dgensearch_003&Ntt=3Dflow+switch&Ntx=3D
>=20
> or
>=20
> http://tinyurl.com/3bwe76
>=20
>=20
> Steve
>=20
>=20
>=20
>=20
>=20
>=20