RE: Comfort Design Question

["ben addison" <ben@xxxxxxxxxxxxxx>]

Hi ben,



All the parts you list below can fit into the comfort panel.

Comfort can have extra zone by using a lem03, which plugs into the min
board.



If you need more help just ask me.



thanks



Ben Addison

Ben Addison Ltd (electrical Contractors)

07889845712

www.benaddison.com

_____

From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Ben McCormack
Sent: 29 May 2008 20:55
To: UKHA Mailinglist
Subject: [ukha_d] Comfort Design Question



Hi All

I am just about to place an order for my Comfort system.

The plan is to install Comfort in a central location and run all
wiring back to this point and I am looking to purchase the following

Comfort Gen 2 Untra II Panel
Backup Battery
KP04 Main Keypad
Door Phone
Phone Protection Board
CBUS Interface
Ethernet Module - UCM01/ETH

Now what is not obvious to me is how all the part physically fit
together. Can all the above be located in the Main Panel?

Now thinking about zones

Initially I will need about 10 zones but this may increase over time
if I put magnetic sensors on each window. So I will need to add extra
zones.

So what is the best way of doing this.

Do I go for a Slave Expansion Panel? Or Unibox?

I am confused about this, can anyone help?

Regards
Ben

[Non-text portions of this message have been removed]





[Non-text portions of this message have been removed]


------------------------------------