Re: Comfort Design Question

[Ben McCormack <yahoogroup@xxxxxxxxxxxxxxxxxxx>]

Ben

As far as I can see if I add an LEM03 I cannot at a later date add any
further Slave Expansion. Have I got this right? The LEM03 leeds me
into a dead end!

Ben


On 30 May 2008, at 00:50, ben addison wrote:

> Hi ben,
>
> All the parts you list below can fit into the comfort panel.
>
> Comfort can have extra zone by using a lem03, which plugs into the min
> board.
>
> If you need more help just ask me.
>
> thanks
>
> Ben Addison
>
> Ben Addison Ltd (electrical Contractors)
>
> 07889845712
>
> www.benaddison.com
>
> _____
>
> From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On
> Behalf Of
> Ben McCormack
> Sent: 29 May 2008 20:55
> To: UKHA Mailinglist
> Subject: [ukha_d] Comfort Design Question
>
> Hi All
>
> I am just about to place an order for my Comfort system.
>
> The plan is to install Comfort in a central location and run all
> wiring back to this point and I am looking to purchase the following
>
> Comfort Gen 2 Untra II Panel
> Backup Battery
> KP04 Main Keypad
> Door Phone
> Phone Protection Board
> CBUS Interface
> Ethernet Module - UCM01/ETH
>
> Now what is not obvious to me is how all the part physically fit
> together. Can all the above be located in the Main Panel?
>
> Now thinking about zones
>
> Initially I will need about 10 zones but this may increase over time
> if I put magnetic sensors on each window. So I will need to add extra
> zones.
>
> So what is the best way of doing this.
>
> Do I go for a Slave Expansion Panel? Or Unibox?
>
> I am confused about this, can anyone help?
>
> Regards
> Ben
>
> [Non-text portions of this message have been removed]
>
> [Non-text portions of this message have been removed]
>
>
>



[Non-text portions of this message have been removed]


------------------------------------