RE: xAP X10 BSC Connector v2.5.0 released

["Edward Pearson" <edward.mailgroup@xxxxxxxxxxxxxxxx>]

------=_NextPart_000_0026_01C5146A.EA5512E0
Content-Type: text/plain;
charset="US-ASCII"
Content-Transfer-Encoding: 7bit

Yes, it was based on your original suggestion. I did it as an experiment
but
didn't progress it further as I realised I should be focussing on releasing
a production quality BSC X10 connector rather than adding extended
functionality. I'll document the schema used and post to the developer
group.

_____

From: Mark Harrison (Groups) [mailto:mph@xxxxxxx]
Sent: 14 February 2005 09:38
To: xap_automation@xxxxxxx
Subject: Re: [xap_automation] xAP X10 BSC Connector v2.5.0 released


Edward Pearson wrote:

> The connector contains an implementation of BSCMapper which can map
> several BSC devices to one 'actual' device. There's no UI for the
> mapper, it's all driven by xAP messages and can be configured using a
> xAP Network Configuration application that I have under development.
> Since the schema definitions for mapper (and groups) are still being
> defined, I turned these functions off in the release code.
>
> Would such mapping functionality fit your security light setup?

Edward,

Do you have documentation for the mapper schema (or does it use the
schema I suggested last year?)

If so, then I think we need to move to document this ASAP - that way I
can port BSC mapper over to being a GUI for this schema, and thus
properly support distributed intelligence.

M.