xAP control of X10 Extended commands via Homeseer

["Jon" <jon00@xxxxxxxxxxxxxx>]

Hi,

I've decided to start transferring my Home Automation setup to xAP. As
some may know, I'm a avid Homeseer fan so most of my automation has
revolved around this.

Anyway to my problem. My house is full of X10 LD11 dimmers which support
extended X10 i.e. if you set a device in Homeseer to be a Leviton 6381,
it will automatically go to any dim level without going to 100% bright
first.

For my first xAP experience, I decided to run my CM12 remotely via
Edwards X10 connector and James Homeseer Plugin.  Everything works fine
with on/off/bright etc but extended commands fail to work.

I have searched the archives and the response before seemed that this is
not supported due to the lack of Extended X10 devices in Europe??

Is there away around this ( going to 100% bright first is not
acceptable!) or will I have to go back to Homeseer controlling my X10
directly?

Thanks,

Jon