Re: Server Crash

["frostie2001uk" <neil@xxxxxxxxxxxxx>]

I moved the TOM10 to the PC and plugged it into the USB port the
same as before the crash. it loaded fine and the xap stuff worked
too.

I then moved it back to it's original location hooked up the mss100
and same problem. I'm thinking it's probably the settings on the com
port redirector. So I'll have a play.

I was a little distracted yesterday as my first lot of X10 stuff
turned up... I got a CM12U and two of the single x10 sockets from
letsautomate. I'll be posting another thread on floorplan and timers
shortly ;)

I hope to look at the MSS100 again tomorrow...

Thanks
Neil

> receive messages from the TOM10  ...  It removes all the xAP
aspects and
> you will just be using
>
> PC<>Redirector<>Network<>MSS100<>TOM10
>
> If you can then you need to focus on the xAP bit- if you can't
then the
> TOM10 connection to the MSS100 or the MSS100 config.
>
> K