The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: Port redirection, was: RE: Who was offering the cheap hosting?


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: component video switching (was svideo->svideo vs. svideo->RGB)


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: component video switching (was svideo->svideo vs. svideo->RGB)
  • From: "Keith Doxey" <lists.diyha@xxxxxxx>
  • Date: Fri, 5 Apr 2002 13:58:24 +0100
  • Delivered-to: ukha_archive@xxxxxxx
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Component Video fed into a Sync On Green capable monitor should display something but you wouldnt line it.
 
You could have to connect as follows
 
Cr-R
Y-G
Cb-B
 
Just guessing about the effect.....
 
SoG is expecting a Signal with a Green Picture and sync, from Component it would get a Monochorme picture (ie ALL the colours would have their brighness information in it).
 
The R & B pins are expecting Red and Blue pictures. Quite what they would make of the colour difference signals I dont know.
 
I would guess you would see a Green Screen version of a B&W picture possible with some wired red and blue patterning. I think you would be happier with the Composite output !
 
The whole paragraph above is largely irrelevant as monitors/TV's with SoG capability are less common than Component inputs.

Keith

www.diyha.co.uk
www.kat5.tv

-----Original Message-----
From: Phil Harris [mailto:phil@xxxxxxx]
Sent: 05 April 2002 13:34
To: ukha_d@xxxxxxxSubject: RE: [ukha_d] component video switching (was svideo->svideo vs. svideo->RGB)


> The Denon does overlay video (configuration settings) onto
> the monitor outputs.  Does that matter too much - since it is
> still just a video signal coming from the outputs?  It can be
> turned off if all else fails.
>
> So, theoretically, if I can get the component video outputs
> into a scart, then my TV should think it is an RGB Signal?? 
> I think this is what the Xbox does - the component video
> outputs are used to make an RGB scart for European Xboxes,
> whereas they can be used directly on the US xbox.

NOOOOOOOOO!

Component video and RGB are quite different formats...

...they just happen to travel down the same spec of cable and have the
same electrical characteristics!

You cannot feed component into an RGB SCART and it work.

Phil



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Yahoo! Groups Sponsor
ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.