RE: Re: Wiring light switches...

["Bricknell, Tony" <tony.bricknell@xxxxxxx>]

Paul,

You say you wish for modules with a quicker response than X10 - I'm about
to
install momentary switches controlling a rack of LD11's and,
understandably,
I'm now concerned...

How are you wiring the switches?  Direct to the LD11's (that's how I
was
intending to do it - minimising any lag in the system) or to something
like
HV that's sending the X10 command out?

Thanks,
Tony

-----Original Message-----
From: psghome2002 [mailto:psghome@xxxxxxx]
Sent: 18 July, 2002 09:40
To: ukha_d@xxxxxxx
Subject: [ukha_d] Re: Wiring light switches...


I recently re-wired my house for momentary switches and LD11's (now 
wish I'd used modules with a quicker response than X10 - but that's 
a different story!). I pretty much left the old cabling and ceiling 
rose structure in place and ran a new 1mm T&E cable to each light 
switch, breaking into the circuit and feeding the LD11's. With 17 
rooms, even that's a LOT of cabling and even though the house is 
only 4 years old, it was a real pig to do as a variety of wall 
construction methods had been used. Works really well though (and 
first time).

Paul.

Yahoo! Groups Sponsor

ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.