As an intermediate step, whilst my Comfort
cannot
be easily programmed (pc in other room), I have dismantled an X10 Appliance
Module and wired it in paralle to my electronic timer.
________AM 10 _________
/ \
/ \
Supply
-<
>----Central heating system
\
/
\_________Randall
timer______/
Theoretically this allow the timer to control
2
set events during the day/night, and the X10 via remote can be used at any
other time.
Unfortunately, sometimes, when heating is on
(timer), it appears to switch the AM10 to ON, meaning the heating
stays
on.....
Also if the timer is on and the x10 is
switched
off...(with or without pressing on), the x10 module will click 4 or 5 times
and remain ON, requiring the timer to be switched OFF before the x10 unit
will
respond properly to the OFF command.
I will remove the timer soon, but anyone any
ideas to prevent this switching, or even any thoughts why this is
so......
thanks
Campbell
For
more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:
ukha_d-subscribe@xxxxxxx
Unsubscribe:
ukha_d-unsubscribe@xxxxxxx
List owner:
ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.