The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: =?iso-8859-1?Q?RE:_=5Bukha=5Fd=5D_Dell_=A399_server_offer_on_again_until_?= =?iso-8859-1?Q?tomorrow?=


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Re: Serial LCD/VFD displays


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Re: Serial LCD/VFD displays
  • From: "Des Gibbons" <des@xxxxxxx>
  • Date: Sat, 15 Feb 2003 17:21:26 -0000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Pictures Patrick, Pictures :)

I am currently fitting 2G backboxes beside lightswitches for displays. What
depth of backbox would you advise? 25mm, 35mm or 47mm , I was thinking of
35mm

Cheers, Des.

> -----Original Message-----
> From: Patrick Lidstone <patrick@xxxxxxx>
> [mailto:patrick@xxxxxxx]
> Sent: Saturday, February 15, 2003 17:12
> To: ukha_d@xxxxxxx > Subject: [ukha_d] Re: Serial LCD/VFD displays
>
>
> Mounted the VFD in a double wall box this afternoon, faced off with
> some green coloured perspex from Rapid. Only mod required was to
> carefully bend serial interface pins to allow connection at 90
> degrees instead of straight back (the display board doesn't fit
> otherwise). I have a fairly long run from node0 to where the display
> sits, and VFDs are very sensitive to voltage drop -- the controller
> wouldn't tolerate a 0.6v drop and I've had to install a local power
> supply nearby to power it. The display does, I have to say, look damn
> good -- even if VFDs themselves tend to look a bit dated.
>
> Less success with the Crystalfontz LCD. The supplied bezel, which I
> had hoped I could cut down, is fractionally too wide (less than a mm)
> to fit into the back box. The acrylic sheet works quite well when the
> display is back lit, so I'll get some more, perhaps in a more neutral
> colour, and make my own bezel.
>
> Patrick
>
>
> http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx > Subscribe:  ukha_d-subscribe@xxxxxxx > Unsubscribe:  ukha_d-unsubscribe@xxxxxxx > List owner:  ukha_d-owner@xxxxxxx >
> List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>


Yahoo! Groups Sponsor
ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.