[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: 1-wire chips - they are small
On Fri, 28 Feb 2003 20:40:35 -0000, you wrote:
>Any advise on how
>best to solder them, before I melt them into oblivion.
I recently made the Elektor serial port 1-wire bus interface (April
2002) and had a few problems with the small SMD parts. What made the
difference was gluing the chip down first, a needle point iron and
very fine solder (not the welding rod stuff most places sell).
By checking the circuit, you may find only a few pins need to be
soldered, reducing the chances of a short circuit.
James
---
James Derrick
james@xxxxxxx, Cramlington, England
Beyond the Horizon of the place we lived when we were young,
In a World of Magnets and Miracles. Pink Floyd.
http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Home |
Main Index |
Thread Index
|