RE: Re: Serial Bridge

["Ian Davidson" <ian@xxxxxxxxxxxxxxxx>]

Dan,

Thanks for the reply. I least I know it's not me doing something wrong
and saves me another few hours seeing if I'd missed something.

Ian D


-----Original Message-----
From: xap_automation@xxxxxxx
[mailto:xap_automation@xxxxxxx] On
Behalf Of danward79
Sent: 01 April 2006 22:01
To: Ian
Subject: [xap_automation] Re: Serial Bridge

Hi,

This is not really of any use to you, but I have had exactly the same
issue.

Unable to get any data except the heartbeat.  Unfortunately Patrick,
does not seem to be answering any of the posts here or the msg I sent
him.

Like you I have confirmed that the serial port and data are good, just
can't get the msgs onto the network.

Dan

--- In xap_automation@xxxxxxx, "Ian Davidson" <ian@...>
wrote:
>
> Hi
>
> I'm trying to get Patrick's serial bridge to work. I have a hub
running
> and the viewer and they can see my Xap traffic. I have run the bridge
> and it is seen in the viewer with a heartbeat every minute. I have
> specified com1 which it acquires correctly. I have com1 linked to com3
> via a serial cross over cable with HyperTerminal running connected to
> com3. (I have tested the com setup with two HyperTerminal windows and
> all is ok). I was expecting to get my Xap traffic out of the com port
> but no data is present. I also tried pasting a Xap packet into the
> HyperTerminal window but it did not show in the viewer although a saw
it
> go out of the port (TX light flicker). Do I need to do anything else?
>
>
>
> Thanks
>
>
>
> Ian D
>