RE: Re: Vendor ID request

[Keith Doxey]

Hi Tony,

I just visited the xapautomation website and had to register although I'm
sure I registered for something in the past. Once I was logged in I
searched
for Vendor ID's just to make sure and couldnt find anything. I also couldnt
find anything about registering an ID on the xAP mailing list either.

I vaugely remember something about it in the past but as I said, I got lost
in xAP and didnt have the time to follow it.

From what I have seen of xPL so far, it already addresses what I considered
to be the most confusing part of xAP. That of targetting messages.

For instance, if I have a KAT5 receiver or Keypad and either an IR command
or a key is pressed I want a message sent with ZoneID=xx ZoneSrc=yy and for
the switcher to respond to that and let the person in Zone XX view source
YY.

xAP seemed to get bogged down in chucking loads of information out without
anything specifically recieving it.

Keith

www.diyha.co.uk
www.kat5.tv


-----Original Message-----
From: Tony T [mailto:<a
href="/group/ukha_xpl/post?postID=M6UGV4nEFX2Sfe7Zv1rVsFmUY4-Q6OfviGBRER4THaCwq_yBTSw8iuEbcNF8BVgaGOJjgKMY3tJx">tony@x...</a>]
Sent: 13 January 2003 21:35
To: <a
href="/group/ukha_xpl/post?postID=BrqCZzmeVE59LxD0vK9T6A8b-Po9a4w_C7b7ptIIu_AumvLDhEgLDbGSrSTt5gPWk3S5UW7g5I_2EqYI4gBo">ukha_xpl@xxxxxxx</a>
Subject: RE: [ukha_xpl] Re: Vendor ID request


> I havent been following the xAP list lately. It got far too heavy for
> me and I realised that there was no way I could handle all the code
> needed in the PIC controllers I will be using.
>
> Would it be right to assume that KAT5 would be earmarked for me ?

Hi Keith,

Everyone who has a current xAP vendor-id, or who requests a vendor-id
(on this list) not currently allocated by xAP can assume they will have
that vendor id. So you are definetly allocated KAT5.

If we decide to have our own list of vendor id's, we'll double check
with all members what vendor id's they require.

Regards
Tony



To unsubscribe from this group, send an email to:
<a
href="/group/ukha_xpl/post?postID=3xUXx6Qj7bgEWEJyarT1GHTAOtW-YX_-mn_C9URiIKi_yb4_XKf1PPtuxEjH3Y4lts8VUqI1dV4W1W-PuO4OVLj2bK_ZAqUyY04IJsF-">ukha_xpl-unsubscribe@xxxxxxx</a>



Your use of Yahoo! Groups is subject to <a href="http://docs.yahoo.com/info/terms/";>http://docs.yahoo.com/info/terms/</a>